Agri-Fab 175 LB. ATV BROADCAST SPREADER 45-03295 - Manual (Page 4)

4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the carton.
Lay out all parts and hardware and identify using the
illustrations on page 2.
FIGURE 1
FIGURE 2
FIGURE 3
4. Assemble the two OUTER hitch braces to the hitch tube
using a 1/4" x 1-3/4" (B) hex bolt and a 1/4" nylock hex
nut (C).
DO NOT TIGHTEN YET. Do not assemble the
inner hitch braces at this time. See figure 2.
1. Turn the spreader upside down as shown in figure 1.
2. Remove the lock nut from the middle bolt in the crossover
tube and shaft support plate. Leave the bolt in place.
See figure 1.
3. Assemble the hitch tube onto the middle bolt and
secure it with the same lock nut you removed. DO NOT
TIGHTEN YET. See figure 1.
IMPORTANT: The hitch tube must attach to the side of the
crossover tube opposite the shaft support plate.
CROSSOVER
TUBE
HITCH
TUBE
SHAFT
SUPPORT
PLATE
MIDDLE
LOCK NUT
MIDDLE BOLT
(B) 1/4" x 1-3/4"
HEX BOLT
(C) 1/4" NYLOCK
HEX NUT
HITCH BRACE
OUTER
HITCH
TUBE
HITCH BRACE
OUTER
5. Assemble a spacer (I), a 3/4" flat washer (G), a wheel
(air valve facing out) and another 3/4" flat washer (G)
onto the end of the axle that has only the
small hole.
See figure 3.
6. Install a 1/8" x 1-1/2" cotter pin (E) into the hole in the
axle. See figure 3.
SMALL HOLE
(I) SPACER
(G) 3/4" FLAT
WASHER
(E) 1/8" x 1-1/2"
COTTER PIN
AIR VALVE
ENGLISH