HP Netserver E Server series - Manual (Page 38)

A Customizing the HP NetServer AutoPilot Server Software
26
To manually install ASR for Novell NetWare:
1. Insert the HP NetServer Navigator CD-ROM in your server's CD-ROM drive, or
logon to a network accessible CD-ROM drive. If you prefer, you may make floppy
diskette masters of the Server Software through the HP Management Solutions
menu of the HP NetServer Navigator.
2. Map a drive letter from the client to the server's SYS:\SYSTEM directory.
3. Copy the files HPASR.NLM, HPRADRV.NLM, and HPLOGAPI.NLM from
x :\autoplt\server\disk1\netware to the SYS:\SYSTEM directory.
Where x is the drive letter for the CD-ROM drive that contains the HP NetServer
Navigator CD-ROM.
4. If you don't want ASR loaded automatically each time your server is started,
remove LOAD HPASR from the server's AUTOEXEC.NCF file.
Note that HPRADRV.NLM and HPLOGAPI.NLM must be present for
HPASR.NLM to function correctly. However, you do not need to separately load
them because HPASR.NLM loads them automatically when it loads.
5. If you want to enable ASR manually, enter the following command from the HP
AutoPilot Client prompt:
LOAD HPASR
ASR NLM Files and Parameters for NetWare
The HPASR .NLM file provides ASR for NetWare. Loading this NLM on a server
enables ASR; unloading it disables ASR (without causing the system to restart itself).
The default time after which the server will restart after a crash or hang is 10 minutes.
The HPASR.NLM file can be dynamically modified with the following command line
parameter:
/t:<timeout> where <timeout> is a number in seconds
Minimum = 300 seconds (5 minutes)
Maximum = 1800 seconds (30 minutes)
Default = 600 seconds (10 minutes)
To change the timeout after loading the NLM, first unload it, and then reload it with a
new parameter.