HP Netserver E Server series - Manual (Page 13)

1
Quick Start
HP NetServer AutoPilot is software that notifies you of problems with your HP
NetServer E Series servers. Installation has two parts: Server software and Client
software. Steps for installing the software differ depending upon whether you have
servers running Novell NetWare or Microsoft Windows NT. If you are an experienced
network administrator, the following Quick Start procedures may be all you need to
install HP AutoPilot.
NOTE Be sure to review the "Required Hardware and Software" section of
Chapter 1 before proceeding.
Steps for Servers Running Novell NetWare
Before proceeding: Identify and list the network names of all the Novell
NetWare servers you want to monitor before starting installation. In addition, be sure
you have supervisor-level privileges for the Novell NetWare servers you want to
include.
At the Client Workstation:
¨ Step 1 Run setup at the client workstation
Insert the HP NetServer Navigator CD-ROM in your HP AutoPilot Client's CD-
ROM drive. From the Windows Program Manager, run setup.exe located in the
autoplt subdirectory.
¨ Step 2 Select an install option
For an initial installation, choose the default option, "Install HP AutoPilot with
the option to install the Server Software." For servers running Novell NetWare,
HP AutoPilot software may be installed on both the client and server(s) while
you're at the client workstation.
¨ Step 3 Select HP NetServers to monitor
For servers running Novell NetWare, installation of the supporting Server software
is also accomplished at the client workstation. From the displayed list, add the HP
NetServers you want to monitor to the "Managed Servers" list box.