Audiovox MVDVD2 - Manual (Page 11)

11
Identification of Control
FRONT PANEL
BACK PANEL
INSTALLATION
MVDVD2
MOUNTING
When choosing a mounting location, the DVD unit should be stable and
in a position where sufficient cooling is available. Before mounting, attach
the supplied brackets and hardware for top or bottom mount.
Plug the supplied cigarette lighter adaptor cord into the back of the DVD
unit and run the wire to a accessory power outlet. (Some vehicles do not
have accessory power outlets. In this case, the cigarette lighter must be
used.) The unit can also be hard wired by connecting wires from the ter-
minal block located on the rear panel of the DVD unit to a 12V DC power
source (be sure to observe correct polarity). Plug the supplied yellow
video cable into the video output of the DVD unit and plug the other end
into the video input of the monitor (not supplied). Repeat this process
with the red and white audio cords. You are now ready to turn on the
power, check the display, insert a movie and press play to begin DVD
operation.