HP ProLiant DL360 G4p Server - Manual (Page 28)

28 HP ProLiant DL360 Generation 4p Server User Guide
3. Lift up on the hood latch handle and remove the access panel.
Installing the Access Panel
1. Place the access panel on top of the server with the hood latch open. Allow
the panel to extend past the rear of the server approximately 8 mm (0.2 in).
2. Engage the anchoring pin with the corresponding hole in the latch.
3. Push down on the hood latch. The access panel slides to a closed position.
Removing PCI Riser Board Assembly
CAUTION: To prevent damage to the server or expansion
boards, power down the server and remove all AC power cords before
removing or installing the PCI riser cage.
1. Power down the server ("Powering Down the Server" on page 25 ).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 26 ).
3. Remove the access panel ("Removing the Access Panel" on page 27 ).
4. Remove the PCI riser board assembly:
a. Disconnect any internal or external cables connected to any existing
expansion boards.
b. Loosen the four PCI riser board assembly thumbscrews.