HP ZBook 17 Mobile Workstation - Manual (Page 67)

6. Grasp the hard drive tab to pull the hard drive (3) out of the hard drive bay.
Installing a hard drive
NOTE: Your computer may look slightly different from the illustration in this section.
To install the hard drive:
1. Insert the hard drive into the hard drive bay at an angle, lay the hard drive flat in the hard drive
bay, and pull the plastic tab (1) towards the center of the computer to engage the hard drive with
the connector.
2. Lock the latch (2), and then tighten the 3 hard drive screws (3).
3. Replace the service door (see Removing or replacing the service door on page 54 ).
4. Insert the battery (see Inserting or removing the battery on page 41 ).
Using hard drives 57