HP LaserJet 5100 Printer series - Manual (Page 120)

B-14 Control Panel Menus
ENWW
RAM DISK
SIZE=xxxK 0K and up
(This value
depends on the
amount of
installed
memory.)
Determine the size of the RAM disk. This item
appears if
RAM DISK = ON or AUTO .
Press [-Value+] to change settings by
increments of 100.
Note
This setting cannot be changed if RAM
DISK=AUTO . Changing this value will cause
the printer to reinitialize when it becomes idle.
JAM RECOVERY=
AUTO AUTO
ON
OFF Determine how the printer behaves when a
paper jam occurs.
AUTO : The printer automatically selects the
best mode for printer jam recovery (usually ON ).
This is the default setting.
ON : The printer automatically reprints pages
after a paper jam is cleared.
OFF : The printer does not reprint pages
following a paper jam. Printing performance
might be increased with this setting.
MAINTENANCE
MESSAGE=OFF OFF This item appears only after the PERFORM
PRINTER MAINTENANCE message displays.
OFF : The PERFORM PRINTER MAINTENANCE
message will be cleared and will not be
displayed again until the next maintenance is
due.
The message should not be turned off unless
the printer maintenance has been performed.
If the required maintenance is not performed,
the printer’s performance will degrade.
NEW TONER
CARTRIDGE=NO YES
NO This item allows the user to tell the printer that
a new print cartridge has been installed.
Setting this item to
YES will reset the HP
TonerGauge to full.
JOB HELD
TIMEOUT=OFF OFF
1 HOUR
4 HOURS
1 DAY
1 WEEK Sets the amount of time that private and proof
and hold jobs are kept before being
automatically deleted from the queue.
Configuration Menu (Continued)
Item Values Explanation