HP LE2001w 20-inch Widescreen LCD Monitor - Manual (Page 16)

LE2001wm Model
1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Connect a VGA signal cable or DVI-D signal cable.
NOTE: The monitor is capable of supporting either analog or digital input. The video mode is
determined by the video cable used. The monitor will automatically determine which inputs have
valid video signals. The inputs can be selected by pressing the +/Source button on the front panel
or through the On-Screen Display (OSD) feature by pressing the Menu button.
● For analog operation, use the VGA signal cable provided. Connect the VGA signal cable to
the VGA connector on the rear of the monitor and the other end to the VGA connector on the
computer.
● For digital operation, use the DVI-D signal cable provided. Connect the DVI-D signal cable to
the DVI connector on the rear of the monitor and the other end to the DVI connector on the
computer.
3. Connect one end of the provided audio cable to the audio connector on the monitor and connect
the other end of the cable to an audio output connector on the rear panel of the computer.
4. Connect one end of the power cable to the AC power connector on the back of the monitor, and
the other end to an electrical wall outlet.
Figure 3-6 Connecting the Cables
5. For cable management, place the cables between the two hooks at the lower section of the
pedestal base. The cables can be neatly secured and hidden when viewed from the front.
8 Chapter 3 Setting Up the Monitor ENWW