HP StorageWorks 2.140 Director Switch - Manual (Page 188)

SANtegrity Security Center 186
eliminating timeouts and retransmissions. If no alternate RADIUS servers are available, which
means that only one server is configured or that all servers are marked as dead, the dead time
is ignored. The dead time can be
0
to
1440
minutes; the default is
0
.
• Click Edit to display the Add/Edit Radius Server dialog box. Use this dialog box to define all the
settings that display in the RADUIS Servers and Sequence table.
• Select one or more RADIUS servers and click Clear to clear the settings.
• Adjust the sequence of RADIUS servers by using the Move Up and Move Down buttons.
• Click Reset to reverse the settings to the initial settings that displayed when the tab was first
accessed.
Applying changes and confirmation
1. Click Apply from the Radius Servers tab.
2. The Security Change Confirmation and Status dialog box is displayed.
This dialog box is similar in behavior to the Security Change Confirmation and Status that is
displayed from the Users tab. The only difference is in the Detailed Changes table. This table
displays the difference between the current settings of the Radius Servers tab and the
to-be-populated new settings.
3. Click Apply or Apply To even if there are no security settings being changed.
If there are no security settings being changed, the Security Change Confirmation and Status
Servers dialog box is displayed with the Detailed Changes table showing that
No Changes
were Found
on the first row.
4. Click Start and the status window displays a message indicating the security settings are
identical and there are no changes to apply.
Viewing the Security Log
You must log in as the Security Administrator or System Administrator to view the Security Log. The
Security Log can be viewed from the following:
• On the HAFM main window, click the Security tab. The Security Log is displayed ( Figure 112 on
page 190) as a table at the bottom of the window.
• On the HAFM main window, select Monitor > Log > Security Log. The Security Log dialog box is
displayed ( Figure 112 on page 190).
• On the Element Manager main window, select Logs > Security Log. The Security Log dialog box
is displayed ( Figure 112 on page 190).