HP Latex 3000 Printer - Manual (Page 7)

Calibrate the Dual Roll Center Support
1. Load a single roll spindle in the the printer.
TIP: Use a single roll spindle to accurately calibrate the height of the Dual Roll Center Support. Do not
use the Dual-Roll Spindle as its heavier weight and it may not be level along its length.
2. Place the Dual Roll Center Support under the center of the spindle.
3. Pull down the lever.
4. Adjust the height of the support by turning it counterclockwise. The bearings at the top of the Dual Roll
Center Support must touch the spindle
ENWW Calibrate the Dual Roll Center Support 3