HP ProLiant DL320 G3 Server - Manual (Page 37)

37
Hardware options installation
In this section
Introduction .................................................................................................................................. 37
Memory options............................................................................................................................ 37
Hard drive options ........................................................................................................................ 39
Installing the CD-ROM drive assembly ....................................................................................... 43
Installing the DVD-ROM drive assembly .................................................................................... 45
Installing the diskette drive assembly........................................................................................... 45
Installing a PCI SCSI array controller or a PCI SCSI controller.................................................. 45
Introduction
If more than one option is being installed, read the installation instructions for all
the hardware options and identify similar steps to streamline the installation
process.
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION: To prevent damage to electrical components,
properly ground the server before beginning any installation procedure.
Improper grounding can cause electrostatic discharge.
Memory options
You can expand server memory by installing PC3200 DDR unbuffered SDRAM
DIMMs. The system supports up to four ECC DDR SDRAM DIMMs.
NOTE: By default, the server is set to Advanced ECC Support. Refer
to "HP ROM-Based Setup Utility (on page
53 )" for more information.
The server supports standard memory configuration for maximum performance
with up to 4 GB of active memory (four 1-GB memory modules).