HP ProLiant DL320 G3 Server - Manual (Page 19)

19
Server operations
In this section
Powering up the server ................................................................................................................. 19
Powering down the server ............................................................................................................ 19
Preparation procedures ................................................................................................................. 20
Extending the server from the rack............................................................................................... 21
Removing the access panel........................................................................................................... 21
Installing the access panel ............................................................................................................ 22
Removing the PCI riser board assembly ...................................................................................... 22
Installing PCI riser board assembly.............................................................................................. 23
Removing the hot-plug SATA backplane..................................................................................... 24
Removing the fan assembly.......................................................................................................... 25
Installing the fan assembly ........................................................................................................... 26
Powering up the server
To power up the server, press the Power On/Standby button.
Powering down the server
WARNING: To reduce the risk of personal injury, electric
shock, or damage to the equipment, remove the power cord to
remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC
power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to
power down the server.
1. Back up the server data.
2. Shut down the operating system as directed by the operating system
documentation.