Configuring the function key operation, Using the touch screen (select models only), Tapping (or clicking) – HP Mini 5102 User Manual

Page 87: Flicking, Tapping (or clicking) flicking

Configuring the function key operation

To configure the function key operation to require the use of the

key (

+ function key), follow these

steps:

Open Computer Setup by turning on or restarting the computer, and then pressing

esc

while the

“Press the ESC key for Startup Menu” message is displayed in the lower-left corner of the screen.

Press

f10

to enter BIOS Setup.

Select the System Configuration menu.

Select the Device Configurations menu.

Select Fn Key Switch, and then select Enable.

Press

f10

to accept the changes you have made.

To save your preferences and exit Computer Setup, use the arrow keys to select File > Save
changes and exit. Then follow the instructions on the screen.

Your preferences go into effect when the computer restarts.

Using the touch screen (select models only)

Some computer models allow you to use your fingers to perform certain actions on the touch screen.

NOTE:

The instructions in this section are based on factory settings. To modify settings for recognized

clicks and flicks, select Start > Control Panel > Hardware and Sound > Pen and Touch.

NOTE:

All movements may not be supported in all programs.

Tapping (or clicking)

Tap or double-tap an item on the screen as you would click or double-click using a TouchPad or an
external mouse. Tap and hold an item to see the context menu as you would use the right TouchPad
button.

NOTE:

You must tap and hold your finger until a circle appears around the area you are touching, and

then the context menu is displayed.

Flicking

Touch the screen in a light, quick flicking motion up, down, left, or right to navigate through screens or
quickly scroll through documents.

NOTE:

For the flicking movement to work, a scrollbar must be visible in the active window.

Configuring the function key operation