Installing the scsi interface cable, Figure a-8, Rear panel components – HP NonStop G-Series User Manual
Page 126: Table a-2
Connecting the Fibre Channel Components for the
CTL700 Tape Library
L700 (CTL700) Installation and User’s Guide — 527338-004
A- 8
Installing the SCSI Interface Cable
is an illustration of where the rear components are located on the
CT9800FC Fibre Channel converter.
Figure A-8. Rear Panel Components
Installing the SCSI Interface Cable
1. Before installing the 68-pin SCSI Cable from the converter to the host, make sure
that the tape library and the converter are both powered off. Refer to
for SCSI cable part numbers.
2. Connect the 68-pin SCSI Cable to the SCSI channel port on the converter.
3. Connect the other end of the 68-pin SCSI cable to a supported SCSI port on a
NonStop S-series server.
Table A-2. Connections Supported for the CT9800FC Fibre Channel Converter
Server
ServerNet / DA
IOMF CRU
IOMF 2 CRU
PMF CRU
S7000
YES
NO
NO
NO
S7400
YES
NO
YES
NO
S70000
YES
NO
YES
NO
S72000
YES
NO
YES
NO
S74000
YES
NO
YES
YES
S76000
YES
NO
YES
YES
S86000
YES
NO
YES
YES
AC Power
Receptacle
Fuse
Power
Switch
LED
Lights
SCSI Channel
Port
GBIC Input
Port
RS-232 Serial Port
(unused)