HP StorageWorks 2.32 Edge Switch - Manual (Page 179)

HA-Fabric Manager user guide 179
Problems with products
Table 19 describes possible product problems and suggested resolutions.
Problems with addresses
Table 20 describes possible problems with addresses and suggested resolutions.
Table 19 Product problems and resolutions
Problem Resolution
HBAs not connected to SAN Check your physical cables and connectors.
Switches not connected to
Ethernet
Check your physical cables and connectors.
Switches not connected to
SAN
Check your physical cables and connectors.
Cannot disable fabric
binding while enterprise
fabric mode is active
Disable the Enterprise Fabric Mode through the
Enterprise Fabric Mode dialog box before
disabling fabric binding.
Table 20 Address problems and resolutions
Problem Resolution
No subnets or addresses
selected
1. Select Discover > Setup.
2. Click on the subnet or individual address you
would like to discover in the Available
Addresses list.
3. Click to move your choice to the Selected
Subnets list, or to the Selected Individual
Addresses list.
4. Click OK.
Wrong IP addresses
selected
1. Select Discover > Setup.
2. Verify that the IP addresses in the Selected
Subnets and Selected Individual Addresses
lists are the correct current addresses for the
SAN.
3. Click OK.
Wrong community strings
are selected
1. Select Discover > Setup.
2. Select an IP address.
3. Click Change.
4. Select the desired community strings.
5. Click OK.