HP ProBook 445 G1 Notebook PC - Manual (Page 51)

Removing the service door
Remove the service door to access the memory module slot, hard drive, regulatory label, and other
components.
To remove the service door:
1. Remove the battery (see Inserting or removing the battery on page 32 ).
2. With the battery bay toward you, remove the screw (1) (if the optional screw is being used, see
Using the optional security screw on page 39 ), and then slide the release latches (2) to release
the service door.
NOTE: You can slide the service door release latches simultaneously or you can slide them
one at a time.
3. Slide the service door towards the front of the computer (3) and lift (4) to remove the service
door.
Replacing the service door
Replace the service door after accessing the memory module slot, hard drive, regulatory label, and
other components.
To replace the service door:
1. Tilt the service door down to align the tabs on the service door with the latches on the computer
(1).
2. Insert the alignment tabs (2) on the rear edge of the service door with the notches on the
computer.
NOTE: The release latches automatically lock the service door into place (3).
Removing or replacing the service door 41