HP 2011x 20-inch LED Backlit LCD Monitor - Manual (Page 29)

● OSD Lockout — The OSD can be enabled or disabled by pressing and holding the Menu button
on the front panel for 10 seconds. If the OSD is locked, the warning message OSD Lockout
appears for 10 seconds.
◦ If the OSD is locked, press and hold the Menu button for 10 seconds to unlock the OSD.
◦ If the OSD is unlocked, press and hold the Menu button for 10 seconds to lock the OSD.
● Dynamic Contrast Ratio ON — Indicates that DCR is turned on.
● Dynamic Contrast Ratio OFF — Indicates that DCR has been turned off in the OSD or was
automatically turned off after changes were made to Brightness or Quick View in the OSD.
● No Input Signal — Indicates the monitor is not receiving a video signal from the computer on
the monitor video input connector. Check to see if the computer or input signal source is off or in
the power-saver mode.
Power-Saver Feature
When the monitor is in normal operating mode, the Power light is Aqua white and the monitor uses the
normal watts of power. For power usage, refer to Technical Specifications on page 27 .
The monitor also supports a power-saver mode that is controlled by the computer. When the monitor is
in the reduced-power state, the monitor screen is blank, the backlight is off, the Power light is amber,
and the monitor uses minimum power. When the monitor is "awakened," a brief warm-up period
occurs before the monitor returns to normal operating mode. The energy-saving reduced power state
activates if the monitor does not detect either the horizontal sync signal or the vertical sync signal. The
power-saver feature must be activated on your computer for this feature to work.
Refer to your computer documentation for instructions on setting energy-saver features (sometimes called
power-management features).
NOTE: The energy-saver feature works only when the monitor is connected to computers that have
energy-saver features.
Power-Saver Feature 23