HP 2011x 20-inch LED Backlit LCD Monitor - Manual (Page 19)

Turning on the Monitor
1. Press the power button on the computer to turn it on.
2. Press the power button on the front of the monitor to turn it on.
CAUTION: Burn-in image damage might occur on monitors that display the same static image on
screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you
should always activate a screen saver application or turn off the monitor when it is not in use for a
prolonged period of time. Image retention is a condition that might occur on all LCD screens. Monitors
with a "burned-in image" are not covered under HP warranty.
* A prolonged period of time is 12 consecutive hours of non-use.
When the monitor is powered on, a Monitor Status message is displayed for five seconds and the
power source LED on the rear of the monitor is green. The message shows which input is the current
active signal, the status of the auto-switch source setting (On or Off), the default source signal, the
current preset display resolution, and the recommended preset display resolution.
HP Watermark and Image Retention Policy
The HP 2011xi IPS and HP 2311xi IPS monitor models are designed with IPS (In-Plane Switching)
display technology which provides ultra-wide viewing angles and advanced image quality. IPS
monitors are suitable for a wide variety of advanced image quality applications. This panel technology,
however, is not suitable for applications that exhibit static, stationary or fixed images for long periods
of time without the use of screen savers. These types of applications may include camera surveillance,
video games, marketing logos, and templates that are displayed on the screen for a prolonged period
of time. Static images may cause image retention damage that could look like stains or watermarks on
the monitor's screen.
Monitors in use for 24 hours per day that result in image retention damage are not covered under the
HP warranty. To avoid image retention damage, always turn off the monitor when it is not in use or use
the power management setting, if supported on your system, to turn off the display when the system is
idle.
Selecting Video Input Connectors
The input connectors are:
● VGA (analog)
● DVI-D connector (digital) select models
● HDMI connector (digital) select models
The monitor automatically scans the signal inputs for an active input and uses that input for the display.
If two inputs are active, the monitor will display the default input source. If the default source is not an
active input, then the monitor will display the other input if it is active. You can change the default
source in the OSD by pressing the front-panel Menu button and selecting Source Control > Default
Source.
Turning on the Monitor 13