HP vp6210 Digital Projector - Manual (Page 33)

6. Maintenance 33
4. Loosen the screw that holds the lamp to the
projector. If the screw is not loosened com-
pletely, they could injure your fingers. It is
strongly recommended that you use a mag-
netic-head screwdriver.
5. Slide the latch to release the lamp.
6. Lift the handle so that it stands up. Use the
handle to slowly pull the lamp out of the
projector.
Pulling it too quickly may cause the lamp to break and
scatter broken glass in the projector.
Do not place the lamp in locations where water might
splash on it, children can reach it, or near flammable
materials.
Do not insert your hands into the projector after the
lamp is removed. If you touch the optical components
inside, it could cause color unevenness and distortion
of the projected images.
7. Insert a new lamp. Make sure the handle is
fully locked and tighten the screw firmly.
Slide the latch so it holds the lamp.
If the screw is loose, it could result in a malfunction.
Do not over tighten the screw.
8. Re-install the lamp cover and tighten the
screw. Do not turn the power on with the
lamp cover removed.
9. Plug in the projector and turn it on.
10. Unplug all input cables.
11. Reset the lamp counter. Do not reset if the lamp is not replaced as this
could cause damage.
i. Press and hold the up button on the projector for 5 seconds to
display the reset message.
ii. Press auto sync on the projector or on the remote control to reset the
lamp hours to “0”.
iii. Wait about 5 seconds to let the message disappear.