Remove the server blade – HP ProLiant BL490c G6 Server-Blade User Manual
Page 12
Operations 12
•
Use the HP BladeSystem Onboard Administrator GUI to initiate a shutdown:
a.
Select the Enclosure Information tab, and then select the Overall checkbox in the Device Bays item.
b.
Initiate a shutdown from the Virtual Power menu:
—
Select Momentary Press to initiate a controlled shutdown of applications and the OS.
—
Select Press and Hold to initiate an emergency shutdown of applications and the OS.
IMPORTANT:
When the server blade is in standby mode, auxiliary power is still being provided.
To remove all power from the server blade, remove the server blade from the enclosure.
After initiating a virtual power down command, be sure that the server blade is in standby mode by
observing that the system power LED is amber.
Remove the server blade
CAUTION:
Do not use the server blade release lever to lift or carry the server blade. Always
support the weight of the server blade by handling the chassis directly. Improper use can damage
the release lever and the server blade.
To remove the component:
1.
Identify the proper server blade.
2.
Power down the server blade (on page
3.
Remove the server blade.
4.
Place the server blade on a flat, level work surface.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the server blade
before beginning any installation procedure. Improper grounding can cause ESD.