HP LaserJet M1120 Multifunction Printer - Manual (Page 39)

Supported network protocols
● TCP/IP
Install the product on a network (network models only)
Connect the product to the network
To connect a network model to a network, you need the following items:
● Wired TCP/IP network
● Ethernet cable (RJ-45)
1. Connect the Ethernet cable to an available port on the Ethernet hub or router.
2. Connect the Ethernet cable to the Ethernet port on the back of the product.
3. Verify that the green light is illuminated on the network port located on the back of the product.
4. Print a configuration page.
NOTE: Do not connect both a USB cable and an Ethernet cable to the product.
Install the software for the network product
To use the product on the network, install the software on a computer that is connected to the network.
ENWW Supported network protocols 29