HP StorageWorks 2.32 Edge Switch - Manual (Page 70)

Setting Up the Application
70 HA-Fabric Manager User Guide
Figure 25: Discover Setup dialog box
2. Specify the IP addresses you want to discover through out-of-band discovery.
You can add, change, and remove IP addresses as necessary. See
“
Configuring IP Addresses and Community Strings ” on page 70 for
instructions.
Note: To correctly discover all SAN products, you must specify each product’s IP
address in the Discover Setup dialog box’s Out-of-Band tab. If you do not configure
the application to discover the devices directly, the connections and attached devices
may not display correctly.
3. Select IP addresses from the Available Addresses table and add them to the
Selected Individual Addresses table by clicking the buttons.
4. Click OK.
5. Turn discovery on or off by choosing Discover > On or Discover > Off.
Configuring IP Addresses and Community Strings
You can configure IP addresses and community strings through which the
application can perform discovery and communication functions.