HP StorageWorks 2.32 Edge Switch - Manual (Page 61)

Setting Up the Application
61 HA-Fabric Manager User Guide
Configuring Remote Access
You can specify the network addresses that can have access to the appliance.
Perform the following to configure remote access:
1. Choose SAN > Remote Access. The Remote Access dialog box displays, as
shown in Figure 21 .
Figure 21: Remote Access dialog box
2. Choose the Allow remote management sessions check box to allow others to
access the appliance remotely.
3. Enter the maximum number of remote sessions you want to allow.
4. Choose whether to allow all or some network addresses to connect from the
Allow options.
5. If you selected Only network addresses below to connect or All network
addresses EXCEPT those below to connect, add and remove addresses in
the table at the bottom of the dialog box.
■ To add an address, click Add, enter a network address, and click OK.
■ To remove an address, select the address from the table and click
Remove.
6. Click OK.