Introduction, Downloading files – HP StoreFabric Converged Network Adapters User Manual
Page 4
Introduction 4
Introduction
Performing a local boot with an FCoE-enabled
network adapter
This guide details FCoE configuration of Broadcom-based, HP FlexFabric and StoreFabric adapters to
perform a local boot only.
Certain adapters might support both hardware-accelerated FCoE and hardware-accelerated iSCSI protocols
on the adapter ports. For any setup and configuration requirements specific to an adapter, see the
documentation for that adapter. To configure a boot from SAN for a remote boot, see the HP Boot from SAN
Configuration Guide
About Broadcom-based, multi-function device drivers
Broadcom-based, multi-function devices use a tiered driver model, and the driver components contain
multiple drivers that support the device. The component version is the virtual bus driver version as contained
in the component. The virtual bus driver is a system device listed under Device Manager. The network device
is a separate driver that is also contained in the component. The network device version is different from the
component version. NCU device properties display both driver versions, and the driver versions are also
listed in Device Manager.
Downloading files
Adapters
1.
Go to the HP website
2.
Select Support, and then select Download drivers.
3.
Type the adapter name in the Find by product box, and then click Go.
For example, type HP FlexFabric 20Gb 2-port 630FLB.
4.
Select the adapter to open the product page.
5.
From the product page, do one of the following:
o
Select the OS to download drivers and firmware as needed.
o
Select Manuals to download documentation.
CNAs
1.
Go to the HP website
2.
Select the adapter.
3.
Select Technical Support/Manuals, and then select Drivers, Software & Firmware.
4.
Download the drivers and firmware as needed.