HP ProLiant ML110 G6 Server - Manual (Page 26)

Hardware options installation 26
Populated slots
(per channel)
Rank Speeds supported
(MHz)
1 Single- or dual-rank 800, 1333, 1066
1 Quad-rank 800, 1066
2 Single- or dual-rank 800, 1066
2
Single-, dual-, or quad-rank 800
Advanced ECC population guidelines
For Advanced ECC mode configurations, observe the following guidelines:
• Observe the general DIMM slot population guidelines (on page 25 ).
• DIMMs may be installed individually.
Single-processor Advanced ECC population order
For Advanced ECC mode configurations with a single processor, populate the DIMM slots in the following
order:
• RDIMM: Sequentially in alphabetical order (A through F)
• UDIMM: Sequentially in alphabetical order (A through F).
Multi-processor Advanced ECC population order
For Advanced ECC mode configurations with multiple processors, populate the DIMM slots for each
processor in the following order:
• RDIMM: Sequentially in alphabetical order (A through F)
• UDIMM: Sequentially in alphabetical order (A through F).
Expansion board options
For server-specific expansion board installation instructions, refer to the installation sheet that ships with the
server.
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the expansion boards.
To install the component:
1. Power down the server (on page 7 ).
2. For ML110 G6 servers, extend the server from the rack.
3. For ML150 G6 servers, do one of the following:
o Unlock and remove the bezel (" Remove the tower bezel (ML150 G6 servers) " on page 8 ).
o Extend the server from the rack.
4. Remove the access panel (on page 7 ).
5. Open the slot cover retainer: