Asus LS99 - Manual (Page 22)

22 Chapter 4 Installing SCSI Drivers
4. Driver Installation
4.2 Windows NT
The adpu160m.sys driver is not embedded on the Windows NT 4.0 installation
disks (or CD-ROM) and must be added during Windows NT installation.
Fresh Windows NT 4.0 Installation From Floppy Disk
1. Create the Windows NT driver disk.
To create the Windows NT driver disk:
a. Insert your ASUS support CD into your CD-ROM drive.
b. Run Windows NT40.exe in e:\SCSI\MakeDisk\
or
Copy the files from e:\SCSI\nt40 (where e is your CD-ROM drive letter) to
a floppy disk.
2. Start your system with the Windows NT startup disk in the floppy disk drive.
3. When prompted, insert disk #2 in your floppy disk drive. After a few moments
you will see a blue screen. To setup Windows NT now, press .
4. Press to skip auto-detection of your SCSI host adapter.
5. Press again to specify an additional device.
6. Press to select Others; insert the floppy disk that you created in step 1
into your floppy disk drive.
7. Using the arrow keys, select the following driver and press :
Adaptec Ultra160 Family PCI SCSI Controller (NT4.0)
8. To add other host adapters that are not part of the Ultra160 Family, press
and repeat from Step 5 for each additional adapter and insert the appropriate
driver disk. The Adaptec Ultra160 Family host adapters use the same driver; it is
not necessary to install the driver again.
9. Press to continue with the Windows NT operating system setup. Follow
the instructions on-screen and in the Windows NT documentation to complete
the installation.
NOTE: Refer to the Ultra160 Family Manager Set User’s Guide (see
ASUS support CD) for more information on installing SCSI drivers.
4.3 Other Operating Systems
Refer to the Ultra160 Family Manager Set User’s Guide (see ASUS support CD) for
detailed installation instructions.