HP StorageWorks 2.32 Edge Switch - Manual (Page 52)

Using the HAFM application 52
Enabling execution options
Perform the following actions until all the firmware is installed on the selected products:
1. Select Pause before starting each action to enable a Continue button on the Install tab.
This gives you more control over the installation process.
2. Select Halt on error to be notified if an error occurs during an installation. If there is an error,
the process stops and the action will not be started on the remaining selected products.
3. Click Next or select the Install tab to display the Confirm Firmware Installation Parameters
dialog box.
Confirming firmware installation
The Confirm Firmware Installation Parameters dialog box lets you confirm group membership and
install firmware ( Figure 16 ).
Figure 16 Confirming Firmware Installation Parameters dialog box
To perform firmware installation:
1. Click Start to begin the firmware installation.
2. If you selected Pause before starting each action, click Continue each time it becomes
enabled.
During firmware installation, the status is displayed. The status can be one of the following:
• Not started
• In Progress
• Failed
• Completed