HP StorageWorks 2.32 Edge Switch - Manual (Page 209)

HA-Fabric Manager user guide 209
Problems with products
Table 25 describes possible product problems and suggested resolutions.
Problems with addresses
Table 26 describes possible problems with addresses and suggested resolutions.
Table 25 Product problems and resolutions
Problem Resolution
HBAs not connected to SAN. Check your physical cables and connectors.
Switches not connected to
Ethernet.
Check your physical cables and connectors.
Switches not connected to
SAN.
Check your physical cables and connectors.
Cannot disable Fabric Binding
while Enterprise Fabric Mode is
active.
Disable the Enterprise Fabric Mode through the
Enterprise Fabric Mode dialog box before disabling
Fabric Binding.
Table 26 Address problems and resolutions
Problem Resolution
No subnets or addresses
selected
1. Select Discover > Setup.
2. Click the subnet or individual address you would
like to discover in the Available Addresses list.
3. Click to move your choice to the Selected
Subnets list, or to the Selected Individual Addresses
list.
4. Click OK.
Wrong IP addresses selected 1. Select Discover > Setup.
2. Verify that the IP addresses in the Selected Subnets
and Selected Individual Addresses lists are the
correct current addresses for the SAN.
3. Click OK.
Wrong community strings
selected
1. Select Discover > Setup.
2. Select an IP address.
3. Click Change.
4. Select the desired community strings.
5. Click OK.