HP ProLiant DL560 Gen8 Server - Manual (Page 46)

Hardware options installation 46
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Determine the status of the drive from the hot-plug SAS drive LED combinations (" Hot-plug drive LED
definitions " on page 14 ).
2. Back up all server data on the drive.
3. Remove the drive.
Installing a hot-plug SAS or SATA hard drive
The server can support five SAS or SATA hard drives in an SFF configuration.
To install the component:
1. Remove the drive blank.