Alpine MOBILE MULTIMEDIA STATION IVA-D900 - Manual (Page 12)

10
-EN
Selecting the Monitor Opening Angle
The monitor opening angle can be set in 2 positions.
Press and hold FLAT/SLIDE for at least 2 seconds
while the monitor is being raised.
Each press changes the monitor angle back or forth.
• When the back-and-force adjustment of the monitor is interrupted
by something cutting in, the monitor functions only opening or
closing.
Adjusting the Monitor Viewing Angle
Adjust the monitor's angle for better visibility.
Press TILT and to adjust the monitor's angle so
the screen will be in the best viewing position.
Pressing the buttons produces a beep and changes the
screen angle between 40 and 105 degrees.
• By pressing TILT or and holding, the angle changes
continuously.
• If the monitor touches an obstacle while the angle is being adjusted
the unit stops the screen immediately.
Should this happen, remove the obstacle and press TILT
or
again.
• The screen color will vary when viewed at certain angles. Adjust
the screen angle for the best viewing position.
• If the voltage of the vehicle's battery power is low, the screen may
blink when the screen angle is changed. This is normal and not a
malfunction.
Moving the monitor to be Flat
When you want to operate some function on the car (air conditioner,
etc.) which is hidden by the raised monitor, use this function.
1
Press FLAT/SLIDE.
The monitor moves to the flat position.
2
Press FLAT/SLIDE again.
The monitor returns to the previous angle.
• The monitor returns to the previous angle from being flat after 10
seconds.
• If an excessive force is added to the monitor when the monitor is
flat, putting an object on the back of the monitor for example, it
may cause a malfunction.
Adjusting the Volume/Balance (Between Left
and Right)/Fader (Between Front and Rear)/
Defeat
1
Press the Rotary encoder repeatedly until the
mode you wish to adjust is obtained.
Each press changes the modes as follows:
VOL. → NAV.* → SUB W.* → BAL. → FAD. → DEFEAT →
VOL.
* NAV. (page 33) and SUBW. (page 23) cannot be adjusted
while they are set to OFF.
Volume: 0 - 35
Balance: L15 - R15
Fader: F15 - R15
Subwoofer: 0 - 15
NAV. MIX: 0 - 15
DEFEAT: ON/OFF
The volume level can be adjusted at any time by just
turning the Rotary encoder.
2
Turn the Rotary encoder to set to the desired
sound within 5 seconds after selecting the mode.
By setting Defeat ON, previously adjusted settings of
BASS and TREBLE will return to the factory defaults, but
MX will be turned off.
• If the Rotary encoder is not turned or pressed within 5
seconds after selecting the Balance, Fader, Defeat and
Subwoofer mode, the unit automatically defaults back to the
Volume mode.
Lowering Volume Quickly
Activating this function will instantly lower the volume level by 20
dB.
Press MUTE to activate the MUTE mode.
The audio level decreases by about 20 dB.
Pressing MUTE again brings the audio back to its previous
level.