HP Integrity rx7620 Server - Manual (Page 27)

A MP Commands
Command Reference: Service Processor (MP or GSP) Commands
Table A-1 lists the commands available from the service processor command menu (the MP:CM>
or GSP:CM> prompt).
The following categories of commands are available:
•
“Service Commands — Service Processor (MP or GSP)” (page 27) .
• “Status Commands — Service Processor (MP or GSP)” (page 27) .
• “System and Access Configuration Commands — Service Processor (MP or GSP)” (page 28) .
Some commands are restricted to users with Operator or Administrator authority. Also note that
the available set of commands may differ depending on the utility revision level and server
hardware model.
For details on these commands, use the help (HE: Help) feature at the service processor Main
menu. Enter the command name at the MP:HELP or GSP:HELP prompt for syntax, restrictions,
and other information.
Table A-1 Service Processor (MP or GSP) Command Reference
Description Command
Service Commands — Service Processor (MP or GSP) Commands for general server complex administration and
nPartition management.
Boot an nPartition past Boot is Blocked (BIB) BO
Display FRU information of an entity DF
Return to the Main menu MA
Modem reset MR
Activate/deactivate a PCI card PCIOLAD
Power entities on or off PE
Reset entity RE
Reset an nPartition for reconfiguration; the nPartition remains inactive, in the shutdown
for reconfig state RR
Reset an nPartition RS
Send a TOC signal to an nPartition TC
Broadcast a message to all users of the MP Command Handler TE
Margin the voltage in a cabinet VM
Display a list of MP connected users WHO
Status Commands — Service Processor (MP or GSP) Commands for displaying hardware and nPartition information.
Display nPartition cell assignments CP
Display the list of available commands HE
Display IO chassis/cell connectivity IO
Display LAN connected console status LS
Display the status of the modem MS
Display detailed power and hardware configuration status PS
Display revisions of all firmware entities in the complex SYSREV
Command Reference: Service Processor (MP or GSP) Commands 27