AOC CT500G User Manual
Page 5
6 J
INSTALLATION INSTRUCTIONS
SWIVEL BASE
To attach the swivel base to the monitor, do the
following:
Carefully turn the monitor on its side or upside down. (see
figure 1)
Locate the cavities at the bottom front of the monitor.
Insert the pegs on the swivel base into these cavities.
Push the swivel base forward until the swivel base locks in
place.
To remove the swivel base, hold the bottom of the swivel
base, then push it out.
POWER CORD
Power Source:
1.
Make sure the power cord is the correct type that
required in your area.
2.
This monitor has a universal power supply that allows
operation in either 100/120V AC or 220/240V AC voltage
area
(No user adjustment is required).
3.
Connect the power cord into your monitor’s power
input socket, and then plug the other end into a 3-pin AC
power outlet. The power cord may be connected to either
a wall power outlet or the power outlet socket on your PC,
depending on the type of power cord supplied with your
monitor.
VIDEO CABLE
Connecting the Video Cable: the monitor comes with a
built-in video cable. Plug the signal cables 15-pin connector
into the computer's video port and tighten the two screws on
the cable connector. (see figure 2)
Caution:Don’t bend the signal cable, otherwise it will
break the inner wire.
Connecting the Power Cord: Plug the power cord into the
monitor's AC power jack. Then plug the power cord into a
grounded AC outlet, UL-approved power strip, or the power
output socket on your PC.
Caution: If the AC outlet is not grounded, install the
proper grounding adapter (not supplied).
OPERATING INSTRUCTIONS
GENERAL INSTRUCTIONS
The power switch is located at front panel of the monitor.
Press the power switch to turn the monitor on or off. The
other control knobs are located at the base of the monitor
(See Figure 3). By changing these settings, the picture can
be adjusted to your personal preferences.
The power cord should be connected.
Connect the video cable from the monitor to the video
card.
To turn the monitor on, press the POWER switch to ON
position. The power indicator will light up.
Your monitor features a unique quick switch system which
provides a picture within seconds after the monitor is
switched on.
NOTES
Do not install the monitor in a location near heat sources
such as radiators or air ducts , or in a place subject to
direct sunlight , or excessive dust or mechanical vibration
or shock.
Save the original shipping carton and packing materials,
as they will come in handy if you ever have to ship your
monitor.
For maximum protection, repackage your monitor as it was
originally packed at the factory.
To keep the monitor looking new, periodically clean it with
a soft cloth. Stubborn stains may be removed with a cloth
lightly dampened with a mild detergent solution. Never use
strong solvents such as thinner, benzene, or abrasive
cleaners, since these will damage the cabinet. As a safety
precaution, always unplug the monitor before cleaning it.