American DJ Sonic Beam II User Manual
Page 5
2. The Sonic Beam II
TM
uses four DMX channels to operate;
Channel 1 is mirror pan, channel 2 is mirror tilt, channel 3 is
gobo/color, and channel 4 is shutter.
3. To run your fixture in DMX mode, plug in the fixture via the
XLR connections to any standard DMX controller. - Follow the
set-up specifications that come with your DMX controller.
Due to fog residue, smoke, and dust cleaning the internal and
external optical lenses must be carried out periodically to opti-
mize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing.
2. Use a brush to wipe down the fan grill.
3. Clean the external optics with glass cleaner and a soft cloth
every 20 days.
4. Clean the internal optics with glass cleaner and a soft cloth
every 30-60 days.
5. Always be sure to dry all parts completely before plugging
the unit back in.
Cleaning frequency depends on the environment in which the
fixture operates (i.e. smoke, fog residue, dust, dew).
©
American DJ Supply
®
- www.americandj.com - Sonic Beam II™ Instruction Manual Page 10
©
American DJ Supply
®
- www.americandj.com - Sonic Beam II™ Instruction Manual Page 9
Sonic Beam II™ Cleaning
Sonic Beam II™ Operation Cont.
Sonic Beam II™ Focusing
1. To focus the Sonic Beam II
TM
it is best to first turn down the
music so the mirror stops moving.
2. Loosen the thumb screw on the front of the unit that hold
the lens in place.
3. Adjust the focus by moving the lens up and down, until you
reach proper focus.
4. Tighten the thumb screws after you achieve your desired
focus.
Sonic Beam II™ Lamp Replacement
Lamp Replacement: Caution! Never open the unit when in
use. Always disconnect the main power before attempting to
replace the lamp. Remember always replace with the same
type lamp and fuse.
1. Be sure to follow the proper procedures when handling
halogen bulbs.
2. Lamp replacement has been made simple by incorporating
the use of a removable lamp tray and thumb screws.
3. Loosen the thumb screw on rear cover.
4. Remove the tray.
5. Remove and replace the bulb.
6. Reassemble.
1. Be sure not to obstruct the cooling vents and keep the
unit in a well ventilated area.
2. Take Caution, never to open the fixture when in use!
3. Always disconnect the main power before servicing or
replacing the lamp.
4. Always replace with the exact same lamp and fuse.
Sonic Beam II™ Operation Precautions