APW Wyott XWAV1829 - Manual (Page 4)

4
Electrical ratings:
Power Cord:
Shipping Weight:
Six (6) foot, 3 wire grounded cord. If the supply cord is damaged, the manufacturer, or an authorized
service agent, must replace it in order to avoid a hazard and warranty. Please contact the factory by
calling the 800 # located on the unit.
XWAV1417 98 lbs. (44.5 kg.); XWAV1422 115 lbs. (52.2 kg.); XWAV1829 149 lbs. (67.6 kg.)
4. INSTALLATION INSTRUCTIONS
If the carton appears damaged, or damage is discovered once the carton is opened, stop
immediately and contact the freight company to file a damage claim.
damp
1. Remove all external packaging that is protecting top portion of unit.
2. Remove unit from shipping container while in the upright position. The unit can be lifted out of the
carton by grasping under the conveyor on each side of the appliance. Please remove the plastic
bag.
3. Remove all internal packaging to the unit.
Remove tape from
conveyor trays. Remove tape from extrusion corners. Remove tape from deflecting curtains
located just above entrance and exit of conveyor.
4. Visually inspect all external and internal portions of unit for damage.
To inspect these white ceramic elements, use a small mirror held under each element to
detect cracks.
5. Wipe down the exterior of the unit using a cloth with warm water. Do not use abrasive pads or
cleaners as they will damage the stainless steel surface and high temperature plastic.
NOTE: DO NOT USE CLEANERS OFANY KIND ON THE WHITE CERAMIC HEATERS.
6.
7. Place unit in operating location.
: Make sure that the operating location is in an area where the
ambient temperature is held constant (minimum 70°F). Please avoid areas such as near
exhaust fans and air conditioning ducts.
Important: Remove urethane supports located
inside the tunnel oven between the top heaters and the conveyor.
Important: Inspect the
top white ceramic elements located inside the oven tunnel after removal of urethane
supports.
Important: The Ceramic elements are fragile and will break under
stress. Do not twist, pull, push, or otherwise subject the white ceramic elements to
stress.
Remove four feet from box and install into threaded nuts located at the four corners underside of the
left and right housings; Also remove conveyor extension tray(s). Conveyor extensions should be
hung off end of conveyor frame. As our standard, Model XWAV1417 will only have one extension
intended for the exit end; Model XWAV1422 and XWAV1829 will have two for loading and exit ends.
Note Ambient Conditions -
MODEL WATTS VOLTS AMPS (1 Phase) NEMA PLUG
4100 208 19.7 6-30P
4100 240 17.1 6-30P
5400 208 26.0 6-30P
5400 240 22.5 6-30P
7200 208 34.6 6-50P
7200 240 30.0 6-50P
XWAV1417
XWAV1422
XWAV1829
CAUTION: The Pass Through Oven is shipped assembled. The unit is shipped with
urethane supports between the top heaters and the conveyor assembly. Please remove
all urethane supports and packaging materials before operating the unit. Failure to
remove all packaging materials may lead to a fire and / or damage to the appliance.
! !