Hardware setup – Asus A7V133 User Manual

Page 38

ASUS A7V133 User’s Manual

Connectors

3. H/W SETUP

3. HARDWARE SETUP

12) Wake-On-LAN Connector (3-pin WOL_CON)

This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that Wake-On-LAN features are enabled
(see 4.4.3 Power Management) and that your system has an ATX power supply
with at least 720mA +5V standby power.

A7V133

A7V133 Wake-On-LAN Connector

IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power

WOL_CON

+5 Volt Standby PME

Ground

13) Wake-On-Ring Connector (2-pin WOR)

This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.

IMPORTANT: This feature requires that Wake-On-Ring features are enabled
(see 4.4.3 Power Management) and that your system has an ATX power supply
with at least 720mA +5V standby power.

A7V Wake-On-Ring Connector

WOR

Ring#

Ground

A7V