Audiovox Rampage ACD88 User Manual
Page 12
12
12
12
12
12
OPEROPEROPEROPEROPER
AAAAA
TTTTT
ING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUC
TTTTT
IONS / SETIONS / SETIONS / SETIONS / SETIONS / SET
TTTTT
ING THE CLOCK / CD ERRING THE CLOCK / CD ERRING THE CLOCK / CD ERRING THE CLOCK / CD ERRING THE CLOCK / CD ERR
OR CODESOR CODESOR CODESOR CODESOR CODES
1. Switch the vehicle ignition and radio “on”.
2. Press the Time/Frequency (T/F) button to call the time display.
3. Within 10 seconds, press and hold the T/F button until a single beep sounds and the
time display flashes.
4. With the display flashing, press the Up MANU/SKIP (
) button to adjust the hours
and A/P indication, or the Down MANU/SKIP (
) button to adjust the minutes to
the correct time.
5. Five seconds after the last hour or minute adjustment is made, the time will be set in
the unit and the display will return to the normal indication.
SET
SET
SET
SET
SETT
TT
TT ING THE CLOCK
ING THE CLOCK
ING THE CLOCK
ING THE CLOCK
ING THE CLOCK
CD PL
CD PL
CD PL
CD PL
CD PLA
A
A
A
AYER ERR
YER ERR
YER ERR
YER ERR
YER ERROR CODES
OR CODES
OR CODES
OR CODES
OR CODES
If a problem should develop while operating the CD player, an error code (ER-1, ER-2,
ER-3, etc.) may appear on the display panel. This can indicate a number of problems
with the unit, including a mechanical error or an error in the microprocessor control of the
player. If an error code should appear, try ejecting and re-loading the disc into the player.
While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly
(label surface up). You may also try activating the RESET button
dm
on the unit, but this
will also erase the time and pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty
station near you for further assistance.
3.To restore the front panel to its normal
operating position, press the release
button in the upper right corner of the
blank panel; the panel will then flip down
to expose the operating controls in the
horizontal position. Simply push in on
the bottom edge of this side to engage
the panel in its normal vertical position.
MODE
BND
SEL
MONO
LOC
EQ
T/F
EJECT
OPEN
LOUD
M
A
N
U
/
S
K
I
P
CD-R/RW PLAYBACK
SCN
MUTE
RPT
3
SCN
2
SHF
4
5
D.DN
D.UP
6
1
PAU
AS/PS
POWER
ACD-88
AF TA TP PTY
MP3
EQ
CDP
EON
LOC
REG
ST
MONO
LOUD
D.DIR
SW
ROCK
CLAS
POP
RELEASE BUTTON
(BLANK SURFACE)
CD EJECT BUTTON
FRONT PANEL IN
NORMAL POSITION
CD EJECT
BUTTON
(REF)
FRONT PANEL IN
REVERSE POSITION
DISC SLOT
PANEL IN FOLD-DOWN POSITION
FRONT PANEL
RELEASE (OPEN)
BUTTON