Audiovox Rampage ACD88 User Manual

Page 11

OPEROPEROPEROPEROPER

AAAAA

TTTTT

ING INSTRUCING INSTRUCING INSTRUCING INSTRUCING INSTRUC

TTTTT

IONSIONSIONSIONSIONS

Play of the disc can be resumed by using
the MODE button

to choose the CD player

function.

TIME/FREQUENCY SELECTOR (T/F)

During radio operation, press this button to
call the time display on the incorporated
quartz clock. The current time will appear
together with an A or P indication. The
display will return to the radio frequency
indication after 5 seconds.
During disc play press of this button to call
the time display. The display will return to
the disc indication after 5 seconds.

EQUALIZER BUTTON (EQ)

The EQ button applies preset sound effects
to the unit’s audio output signal.The EQ
button, when pressed, will activate one of
the following operating modes ( CLASSICS,
POP M, ROCK M, DSP OFF or FLAT). Even
though the Equalizer function is active, as
displayed on the panel, if the bass and/or
treble level is set, the Equalizer function
automatically returns to the FLAT mode.
Conversely, when the Equalizer function is
not active, the unit returns to the user set
bass and treble levels.

RESET BUTTON

The Reset button is located to the right of
the SCN button on the front panel. The reset
circuitry should only be activated under the
following circumstances as it will erase
the time and pre-set memories:

1.Upon initial installation after all wiring is

completed.

2.If there is a malfunction of any of the

switches on the unit, pressing the Reset
button may clear the system and return
to normal operation.

FRONT PANEL RELEASE BUTTON

(OPEN)
This button is used to release the
mechanism that holds the front panel to the
chassis. To fold down the front panel, press
the button so that the panel drops to the
lowered position. To reverse the panel and
show only a blank surface, grasp the panel
at the outer edge and press it up into
position. This will give the appearance that
no front panel exists. To return the front
panel to its normal position, press the
release button in the upper right corner of
the blank surface; the panel will then fold
down. Press in on the bottom edge to
reposition the panel in its normal playing
position.

REMOTE SENSOR

The sensor to detect the infrared signal from
the wireless remote control is located behind
the LCD display lens. For optimum operation
of the remote control, always aim the control
at the LCD display.

NOTES ON USE OF FRONT PANEL:

1.When the OPEN button is pressed in the

lower right corner of the front panel, the
panel folds down into the horizontal
position; in this position, compact discs
can be loaded into the CD player. Then
the panel can be returned to the normal
vertical position by pressing inward and
upward on the lower edge of the panel.

2.To reverse the panel surface (the back of

the front panel), repeat step 1 above, and
raise the underside of the bottom edge,
folding the back side of the panel upward
so that the blank side of the panel is
facing outward. Press in until the panel
clicks into place.