Avocent ESP Multi-Interface Serial Hub SuperSerial - Manual (Page 13)

13
Equinox ESP Multi-Interface Serial Hub Product Installation Guide
2.5 UnixWare
The following sections contain procedures for installing the ESP driver on a
UnixWare release 7.0.1a or higher system.
2.5.1 Creating and Using UnixWare ESP Installation Diskettes
on UnixWare
1. Mount the CD-ROM volume using the following command:
mount -f cdfs -0 fperm=0555,nmconv=c -r/dev/cdrom/
c0b0t110/mnt
2. Run the following commands:
cd /mnt [or other mount point]
./makeunix.sh
3. Follow the on-screen instructions to build an installation diskette for
UnixWare ESP.
4. Once the UnixWare installation diskette is created, refer to the following
le for detailed installation instructions: /drivers/esp/unixware/readme.txt
2.5.2 Creating and Using UnixWare ESP Installation Diskettes
on DOS
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
2. Set your default drive to the CD-ROM drive letter.
3. Run the command
MAKEUNIX and select the appropriate Equinox
product and operating system for which diskettes are needed.
4. Once the UnixWare installation diskette is created, refer to the following
le for detailed installation instructions: /drivers/esp/unixware/readme.txt
2.5.3 Creating and Using UnixWare ESP Installation Diskettes
on Microsoft Windows
1. Load the Equinox SuperSerial Software CD in your CD-ROM drive.
• If you have autoplay enabled, the Equinox SuperSerial Software
Installation screen will appear.
• If you do not have autoplay enabled, set your default drive to
D: and run the command D:\SETUP, where D: is your CD-ROM
drive letter.
2. Click UNIX on the Main Window.
3. Select the UNIX operating system for which you need drivers. Follow
the on-screen instructions for creating an installation diskette.
4. Once the UnixWare installation diskette is created, refer to the following
le for detailed installation instructions: /drivers/esp/unixware/readme.txt