Avocent ESP Multi-Interface Serial Hub SuperSerial - Manual (Page 12)

12
Equinox ESP Multi-Interface Serial Hub Product Installation Guide
2.4.3 Creating and Using OpenServer ESP Installation
Diskettes on DOS
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
2. Set your default drive to the CD-ROM drive letter.
3. Run the command
MAKEUNIX and select the appropriate Equinox
product and operating system for which diskettes are needed.
4. Once the OpenServer installation diskette is created, refer to
the following le for detailed installation instructions:
/drivers/esp/sco/readme.txt
2.4.4 Creating and Using OpenServer ESP Installation
Diskettes on Microsoft Windows
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
• If you have autoplay enabled, the Equinox SuperSerial Software
Installation screen will appear.
• If you do not have autoplay enabled, set your default drive to
D: and run the command D:\SETUP, where D: is your CD-ROM
drive letter.
2. Click UNIX on the Main Window.
3. Select the UNIX operating system for which you need drivers. Follow
the on-screen instructions for creating an installation diskette.
4. Once the OpenServer installation diskette is created, refer to
the following le for detailed installation instructions:
/drivers/esp/sco/readme.txt