LG DU-27FB34C - Manual (Page 52)

Page 52
QuickSet II Programmer
LT2000
®
ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS, USA
• heartbeat power on communications ok
• slow power on
no communications
• green battery ok
• red battery low
Blink pattern
Color Reset
Status Indicator
Connect cable to
TV MPI Jack and
follow on screen
instructions
MPI
Antenna
Cable
Typical
TV Back
M.P.I.
Component Video Input
R Audio In L
R Audio L
Video In Y
Pr Pb
Matrix Out
LT200 2
Clone Programmer
TV Back Panel
(Expanded View)
RF Coxial Wire
(75 ohm)
Antenna
Learn Master TV Setup
Typical MPI Connections
QuickSet II Programmer
LT2000
®
ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS, USA
• heartbeat power on communications ok
• slow power on
no communications
• green battery ok
• red battery low
Blink pattern
Color Reset
Status Indicator
Connect cable to
TV MPI Jack and
follow on screen
instructions
MPI
Antenna
Cable
Typical
TV Back
M.P.I.
Component Video Input
R Audio In L
R Audio L
Video In Y
Pr Pb
Matrix Out
LT200 2
Clone Programmer
TV Back Panel
(Expanded View)
RF Coxial Wire
(75 ohm)
Antenna
Teach Other TV the Setup
Typical MPI Connections
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
LT2002 QuickSet Clone Programmer
Use the LT2002 QuickSet II “Clone”
Programmer to copy the setup from a
“master” TV then quickly transfer the
setup to duplicate TVs; must be the
same model number as the master TV.
LT2002 LT2002
The optional QuickSet II Clone Programmer (LT2002) allows custom setup and pro-
gramming information to be quickly copied from a master TV into multiple identi-
cal television sets. Once learned from the master, setup data is retained in the
LT2002 for future use.
When using the LT2002, cloning operations will go easier if the TV set is connect-
ed to a good quality signal and operating with a stable picture displayed. To oper-
ate the LT2002, use the indicated keys on the HP602, LP702 or MBR3447 LG
remotes, or the front panel keys on the TV receiver.
Notes: Use MPI port for cloning. Do not run Auto Program while cloning.