LG 50PG20-UA - Manual (Page 24)

CHANNEL SETUP
W
ATCHING
TV
22
TURNING ON TV
WATCHING TV
NOTE !
G G If you intend to be away on vacation, disconnect the power plug from the wall power outlet.
First, connect power cord correctly.
At this moment, the TV switches to standby mode.
■ In standby mode to turn TV on, press the , IIN NPPU UTT, C CH H (( D D or E E )) button on the TV or press the
PPO OW WEERR, IIN NPPU UTT, C CH H(( or )), N Nuum mbbeerr ((0 0~9 9 )) button on the remote control.
Select the viewing source by using the IIN NPPU UTT button on the remote control.
■ This TV is programmed to remember which power state it was last set to, even if the power cord is out.
When finished using the TV, press the PPO OW WEERR button on the remote control. The TV reverts to standby
mode.
1
2
3
Auto Scan (Auto Tuning)
Automatically finds all channels available through antenna or cable inputs, and stores them in memory on the
channel list.
Run Auto Tuning again after any Antenna/Cable connection changes.
Select C CH HAAN NN NEELL.
Select AAuuttoo TTuunniinngg.
Select YYeess.
Run AAuuttoo ttuunniinngg.
1
MENU
3
2
ENTER
ENTER
4
ENTER
■ A password is required to gain access to
Auto Tuning menu if the Lock System is
turned on.
5
RETURN
Return to the previous menu.
MENU
Return to TV viewing.
Enter Move
CHANNEL
Auto Tuning
Manual Tuning
Channel Edit
Enter Move
CHANNEL
Auto Tuning
Manual Tuning
Channel Edit
Press ‘Yes’ button to begin
auto tuning.
Yes
No
MFL34797073-en-simple 8/6/08 8:32 PM Page 22