Accton Technology SWITCHUB-2S 100BASE-TX - Manual (Page 24)

SwitcHub-2s User’s Guide
2-10 Hardware Description
Rear Panel
The unit’s rear panel includes two logical Ethernet ports and a full-range power
socket. Although 10BASE-T and 100BASE-TX connections are automatically
sensed by the SwitcHub, you must use the Configure button to set the data
transfer mode to full-duplex or half-duplex operation, as described under
Setting
the Communication Mode in this chapter. The following figure shows the rear panel.
Figure 2.3 The SwitcHub-2s Rear Panel
Ethernet Ports
The SwitcHub has 2 logical RJ-45 Ethernet ports – one MDI-X port for
connecting to a workstation or server and one MDI port for connecting to
another network interconnection device, such as a hub or switch. When using
Fast Ethernet, these ports can also be connected to devices such as a high-speed
server or Ethernet backbone. Use straight-through twisted-pair cable to connect
to any of the switching ports.
Note: Either the Port 1 or Port 2 MDI port can be used as a daisy-chain port to connect
the switching hub to other compatible hubs using straight-through twisted-pair cable
.
Power Socket
The power socket accepts AC power from 100 to 240V at 50 to 60Hz. The unit
is equipped with a universal full-range power source.