Agri-Fab 45-03011 - Manual (Page 5)

5
FIGuRE 6
PLASTIC
KNOB
NYLON
WASHER
1/4" x 3/4"
CARRIAGE BOLT
FLOW
CONTROL
GAUGE
14. Assemble the flow control gauge to the hopper brace
using the 1/4" x 3/4" carriage bolt, a nylon washer and
the plastic knob. See figure 6.
nOTE: The wheels may be temporarily removed for easier
access when assembling the tongue braces in the
following instructions.
10. Insert a tongue brace through the slot in the end plate.
Fasten the front hole of the tongue brace to the end plate
using a 1/4" x 5/8" hex bolt and 1/4" hex nut. For the rear
hole use a 1/4" x 3/4" hex bolt, 1/4" flat washer and 1/4"
hex nut, with the bolt and washer assembled from inside
the poly hopper. See figure 5.
Do not tighten yet.
11. Fasten the other end of the tongue brace to the side of
the tongue using two 1/4" x 5/8" hex bolts and 1/4" hex
nuts.
Do not tighten yet. See figure 5.
12. Repeat steps 10 and 11 for the second tongue brace.
13.
Tighten all bolts and nuts assembled so far.
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK
NUT
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK NUT
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
WHEEL REMOVED
FOR ACCESS
FIGuRE 5
15. Check that both ferrules are adjusted so that approximately
ten threads (1/2") of the control rod is exposed. Insert
both ferrules into the brackets which are riveted to the
front of the flow plates. Assemble a 1/4" hex lock nut
onto each ferrule, making only
finger tight at this time.
See figure 7.
1/4" NYLOCK NUT
BRACKET
FERRULE
FIGuRE 7