Agri-Fab 45-03011 - Manual (Page 3)

3
A B C D E F
J K
L
G
H
I
SHOWN FULL SIZE
NOT SHOWN FULL SIZE
O P
M
N
REF. QTY. DESCRIPTIOn
A 1 Hex Bolt, 3/8" x 1"
B 2 Hex Bolt, 1/4" x 1-3/4"
C 1 Hex Bolt, 1/4" x 1-1/4"
D 2 Hex Bolt, 1/4" x 3/4"
E 16 Hex Bolt, 1/4" x 5/8"
F 1 Carriage Bolt, 1/4" x 3/4"
G 24 Nylock Nut, 1/4"
H 1 Nylock Nut, 3/8"
REF. QTY. DESCRIPTIOn
I 10 Flat Washer, 1/4"
J 3 Nylon Washer
K 1 Hitch Pin
L 1 Hair Cotter Pin, 1/8"
M 1 Transport Handle Grip
N 1 Control Arm Grip
O 1 Plastic Knob
P 2 Ferrule
FIGuRE 1
1/4" NYLOCK NUT
1/4" x 5/8"
HEX BOLT
TONGUE
FRAME ASSEMBLY TUBE
TOOLS REQuIRED FOR ASSEmBLY
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
(2) 3/4" or Adjustable Wrenches (for optional wheel removal
in figure 5)
ASSEmBLY
1. Remove the hardware pack and all individual parts from
the carton and lay out as shown on pages 2 and 3.
2. Assemble the end of the tongue to the hopper as shown
in figure 1 using two 1/4" x 5/8" hex bolts and 1/4" hex
nuts. The holes are located just below the frame assembly
tube.
Do not tighten yet.
Spike points are sharp. Exercise caution when
working with hands near spike disks.