Agri-Fab 45-03011 - Manual (Page 4)

4
FIGuRE 2
1/4" NYLOCK NUT
1/4" NYLOCK NUT
1/4" x 5/8"
HEX BOLT
1/4" FLAT
WASHER
1/4" x 1-3/4"
HEX BOLT CENTER BRACE
3. Attach the tongue to the frame assembly tube using
two 1/4" x 1-3/4" hex bolts, four 1/4" flat washers and
two 1/4" hex nuts as shown in figure 2.
Do not tighten
yet.
4. Attach the tongue to the two center braces using four
1/4" x 5/8" hex bolts and 1/4" hex nuts as shown in figure
2.
Do not tighten yet.
5. Assemble the plastic grip onto the end of the flow control
arm as shown in figure 3.
6. Insert the flow control arm through the slot in the hopper
brace. Place a nylon washer on each side of the arm
and attach it to the brace's welded bracket using a 1/4" x
1-1/4" hex bolt, a 1/4" flat washer and two 1/4" hex lock
nuts as shown in figure 3.
Tighten the first hex lock nut
until there is noticeable resistance when moving the flow
control arm, then
tighten the second hex lock nut.
7. Place the flow control rod through the hole at the end
of the flow control arm. Assemble the two ferrules onto
the threaded ends of the rod so that approximately 10
threads (1/2") of the rod extends through the ferrules.
See figure 3.
FIGuRE 3
NYLON
WASHER
1/4" NYLOCK
NUTS
1/4" FLAT
WASHER
1/4" x 1-1/4"
HEX BOLT PLASTIC
GRIP
FERRULE
FLOW
CONTROL
ROD
FLOW
CONTROL
ARM
HOPPER
BRACE
1/2"
FIGuRE 4
3/8" HEX
NYLOCK NUT
1/4" x 5/8"
HEX BOLT
3/8" x 1"
HEX BOLT
1/4" FLAT
WASHER
(ONE ONLY)
1/4" HEX NUT
HOPPER
BRACE
HITCH
BRACKET
8. Attach the hopper brace to the hopper using two 1/4"
x 5/8" hex bolts, one 1/4" flat washer and two 1/4" hex
nuts.
Do not tighten yet. See figure 4.
9 Place the end of the hitch bracket with two holes down
through the slot in the tongue. Attach the hopper brace to
the top of the tongue and the hitch bracket to the bottom
using one 3/8" x 1" hex bolt, 3/8" lock washer and 3/8"
hex lock nut.
Do not tighten yet. See figure 4.