American Dryer Corp. ML-145 - Manual (Page 9)

5
SECTION II
ROUTINE MAINTENANCE
A. CLEANING
A program and/or schedule should be established for periodic inspection, cleaning, and removal of lint from
various areas of the dryer, as well as throughout the duct work system. The frequency of cleaning can best be
determined from experience at each location. Maximum operating efficiency is dependent upon proper air
circulation. The accumulation of lint can restrict this airflow. If the guidelines in this section are met, an ADC
dryer will provide many years of efficient, trouble free, and – most importantly – safe operation.
WARNING: LINT FROM MOST FABRICS IS HIGHLY COMBUSTIBLE. THE
ACCUMULATION OF LINT CAN CREATE A POTENTIAL FIRE HAZARD.
WARNING: KEEP DRYER AREA CLEAR and FREE FROM COMBUSTIBLE
MATERIALS, GASOLINE and OTHER FLAMMABLE VAPORS and
LIQUIDS.
NOTE: Suggested time intervals shown for average usage which is considered six (6) to eight (8)
operational (running) hours per day.
Clean lint drawer and screen every third or fourth load.
NOTE: Frequency can best be determined at each location.
DAILY
(beginning) of each work shift.
Clean lint from the drawer and screen. Inspect lint screen and replace if torn.
WEEKLY
Clean lint accumulation from lint chamber, thermostat, and microprocessor temperature sensor (sensor bracket)
area.
WARNING: To avoid the hazard of electrical shock, discontinue electrical supply to dryer.
STEAM DRYERS
Clean steam coil fins using compressed air and a vacuum cleaner with brush attachment.
NOTE: When cleaning steam coil fins, be careful not to bend the fins. If fins are bent, straighten by
using a fin comb which is available from local air conditioning supply houses.
90 DAYS
Remove lint from tumbler (basket), drive motors, and surrounding areas. Remove lint from gas valve burner area
with a dusting brush or vacuum cleaner attachment.