Audiovox Portable CD System User Manual

Page 2

1. Set the FUNCTION switch to

CD. "

" is shown in the dis-

play.

2. Open the CD door. Place a disc

in the center with the label side

up and then close the CD door

gently. The total number of

tracks will show in the display.

3. Press PLAY/PAUSE button ( )

to start CD play. The Play /

PAUSE indicator will light.

Adjust the VOLUME.

USING THE CD PLAYER

RADIO OPERATION

You can listen to your favourite radio

stations by sliding the FUNCTION

switch to RADIO, and then

1. Using the BAND switch to choose

AM(MW) or FM.

2. Using the TUNING control to

choose a station.

Adjust the VOLUME.

AM (MW)

Repositioning the unit to get better

AM (MW) reception.

POWERING UP

AC POWER

You can power your portable stereo

system by plugging the detachable AC

power cord into the AC inlet on the

back of the unit and into a wall AC

power outlet.

Check that the rated voltage of your

unit matches your local voltage.

Make sure that the AC power cord is

fully inserted into the unit.

Caution: To prevent electrical shock,

match wide blade of plug to wide slot,

fully insert.
BATTERY POWER

Insert 8 "C" size batteries in the

battery Compartment. Be sure that the

batteries are inserted correctly to avoid

damage to the unit.

Note on the batteries

Always remove the batteries when

unit will not be used for a long

period of time, as this will cause

leakage to the batteries and

subsequently damage to your set.

TO WALL AC OUTLET

TO AC INLET

Adjust the Volume.

WHEN RECORDING

The VOLUME control may be adjusted

with no effect on the recorded signal.

ADJUSTING THE SOUND

NAMES OF CONTROLS

1. PROGRAM/(REPEAT) button

2. SKIP (reverse) button

3. SKIP (forward) button

4. PLAY/PAUSE button
5. CD display

6. STOP button

7. Cassette compartment

8. Cassette deck operation controls

STOP button

F.FWD button

REW button

PLAY button

REC button

Antenna

10. TUNING control

11. Dial scale

12. PROGRAM indicator

13. FUNCTION switch (Tape/Radio/

CD)

14. BAND switch

15. CD door

16. PHONES jack

17. VOLUME control

18. AC socket

19. Battery compartment

TO INTERRUPT PLAYBACK

Press (

)PLAY/PAUSE again

to resume play.

PROGRAM PLAY (IN STOP MODE)

1. Press the PROGRAM button. The

PROGRAM indicator blinks and

"0" flashes in the CD display.

2. Press the ( / ) SKIP button

until the desired track appears on

the CD display.

3. Press the PROGRAM button to

as the first selection. The track

no. indication will be returned

to "0".

5. Press (

)PLAY/PAUSE button.

During program playback, the

PROGRAM indicator blinks.

NOTE: Programming can only be

done when the unit is in the stop

mode.

TO SKIP TO THE BEGINNING OF A TRACK

Press either one of the or

(skip)

button according to the desired direction.

Each press skips one track. During play,

the first press on the skip backwards button

( ) skips to the beginning of the current

track.

Playback resumes from the selected track.

TO CHECK WHAT HAS BEEN

PROGRAMMED

1. Press the PROGRAM button. The

program indicator blinks.

2. Press (

)PLAY/PAUSE button.

3. Press the ( ) SKIP/SEARCH button.

This function allows one track, all tracks on a disc or the programmed tracks

only to be played repeatedly.

REPEAT PLAY (IN PLAY MODE)

TO REPEAT THE SAME TRACK

Press the PROGRAM button once

during playback, the repeat indica-

tor will blink.

TO REPEAT THE WHOLE DISC OR

PROGRAMMED TRACKS

Press the PROGRAM button a sec-

ond time to repeat all tracks, the re-

peat indicator will light.

TO CANCEL REPEAT PLAY

Press the PROGRAM button until

the repeat indicator is turned off.

NOTE: Repeat play can only be done

when the unit is in the play mode.

TO STOP PLAYBACK
Press ( ) STOP to stop disc play.

Each press skips one track

4. Repeat steps 2 and 3 until all the

desired tracks are programmed

(up to 19 tracks).

Note: After listening, set the FUNCTION switch to TAPE.

TO CLEAR THE PROGRAM

Set the FUNCTION switch to TAPE or RADIO.

Open the CD door (during stop mode).

CD DISPLAY

TO SEARCH THROUGH TRACKS

Search function is possible only in playback

mode.

Keep either one of the or (skip)

button pressed, according to the desired

direction, and release at the desired point.

Keep it pressed during play

Press ( )PLAY/PAUSE button

while a CD is playing to pause

play (the PLAY/PAUSE indicator

will blink).

Play " " indicator
Pause " " indicator
Repeat all " " indicator
Repeat one " " indicator

Track number

Playback would automatically come to a stop when the batteries have

no more power. Replace all the batteries with new ones.

Do not mix old and new batteries. Do not mix ALKALINE, standard

(CARBON-ZINC) or rechargeable (NICKEL-CADMIUM) batteries.

For private listening

Connect headphone (Ø3.5mm stereo mini-plug) to the PHONES jack.

When headphones are connected, the speakers are automatically discon-

nected.

! " # $ %

1.5V