Bosch WTB86200UC - Manual (Page 15)

15
To adjust the dryer feet:
1. Install the dryer on a level and solid surface, preferably
in a corner of a room.
2. If the floor is uneven (or not level) adjust the dryer feet
as required to level the dryer. Do not place anything
under the dryer feet to help level the dryer.
3. Extend the dryer feet no more than is necessary. The
more the feet are extended, the more vibration the
dryer will experience. Start with the dryer feet turned all
the way in and adjust each foot as necessary.
4. Use a bubble level to check the top of the dryer to
make sure it is level side to side and front to rear.
5. Press down on each corner of the dryer top to make
sure the dryer does not “wobble“. There should be no
"give" or movement. All four dryer feet should press
equally against the floor. This is just as important as
the dryer being level to prevent vibration.
Check heating system
1. Check that the drum is empty.
2. Close the dryer door.
3. Switch the dryer to Extra Dry and then press the
Start/Pause button.
4. After 3-5 minutes press the Start/Pause button and
open the door.
▯
If the interior of the dryer feels warm, the dryer has
been connected properly. Switch the dryer to Off.
▯
If the dryer does not work, switch the dryer to Off.
Look in the Troubleshooting section of this user
manual and find the fault.
Preparing to transport the dryer - step by
step
1. Rotate the program selector to Off.
2. Pull out power supply plug.
3. Place any accessories in the drum.
4. Close the door and secure with adhesive tape.
5. Screw the height-adjustable feet of the dryer into the
housing to prevent them from being damaged during
transportation.