Electrolux ZCS2100 - Manual (Page 10)

8 7 6 5
4 3 2 1
13
12 11 10 9
English
GETTING THE BEST RESULTS
Use the nozzles as follows:
Carpets: Use the carpet/hard floor nozzle with the lever in
position (1). Reduce suction power for small carpets.
Hard floors: Use the carpet/hard floor nozzle with the lever
in position (2). If you have a carpet/hard floor nozzle with two
pedals – press the pedal on the right (3) to vacuum up animal
hair, etc. more effectively.
Wooden floors: Use the parquet nozzle (certain models
only, 4).
Upholstered furniture: Use the combination nozzle as
shown in (5).
Curtains, lightweight fabrics, etc.: Use the combination
nozzle as shown in (5). Reduce suction power if necessary.
Frames, bookshelves, etc.: Use the combination nozzle as
shown in (6) or Easy clean (7 – certain models only).
Crevices, corners, etc.: Use the crevice nozzle (8).
Using the power nozzle
(Requires an Classic Silence equipped with a power socket. The
power nozzle is delivered only with certain models, or could be
bought as an accessory.)
9 Attach the nozzle to the tube.
10 Connect the power nozzle to the socket on the vacuum
cleaner.
11 Use the clips to secure the cable along the tubes and
hose.
12 The power nozzle starts operating when the vacuum
cleaner is switched on.
Using the turbo nozzle
(certain models only)
13 Attach the nozzle to the tube.
Note: Do not use the power or turbo nozzle on skin rugs, rugs
with long fringes or a pile depth exceeding 15 mm. To avoid
damaging the carpet, do not keep the nozzle stationary whilst
the brush is rotating. Do not pass the nozzle across electric cab-
les, and be sure to switch off the vacuum cleaner immediately
after use.
10