Electrolux EIDW5905JS - Manual (Page 5)

5 Operating Instructions
GETTING STARTED
NORMAL OPERATING
SOUNDS
To run your dishwasher, follow these
basic steps:
1 Load dishwasher. (See Preparing and Loading
Dishes, pages 8-10.)
2 Add detergent. (See Dishwasher Dispenser &
Detergents, pages 11-12.)
3 Add rinse aid, if needed. (See Rinse Aid,
page 13.)
4 Select desired CYCLE. (See Cycle Selections,
pages 5 -7.)
5 Select desired OPTIONS. (See Energy
Options Selections, page 5-7.)
The option LED will illuminate when selected.
6 To start, press START/CANCEL pad and close
door. (See Start/Cancel, page 7.)
Press and hold HI-TEMP icon for 5 - 10 seconds before first use.
EIDW5905
Though your dishwasher has many enhancements
to reduce its sound level, it is normal to hear some
of what is going on inside. The wash cycles
include several instances of water entering the unit
(splashing), the wash pump running to spray water
on the dishware (motor & splashing) and the drain
pump running to discharge the dirty water and
soils. Variations in the pumping/spraying sounds
are also normal. During a cycle the pump switches
on and off many times and the spray pressure is
adjusted up and down throughout to provide the
best cleaning performance.
Cycle times are approximate and vary by options
selected. Hot water is necessary to activate
dishwasher detergent and melt fatty food soils.
An automatic sensor checks the water temperature
fhroughout each cycle. When HI-TEMP WASH is
selected, the unit heats the water to an even higher
temperature. Run hot water faucet nearest
dishwasher until water is hot before starting.
WASH CYCLE SELECTIONS
The cycle LED will illuminate when selected.